Show simple item record

dc.contributor.authorE. G. Thomsen
dc.contributor.authorA. H. Shabaik
dc.contributor.authorS. Sohrabpour
dc.date.accessioned2017-05-08T23:02:54Z
dc.date.available2017-05-08T23:02:54Z
dc.date.copyrightJuly, 1977
dc.date.issued1977
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26855#252_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/89897
dc.description.abstractThe present paper deals with a modified tension test with experimental results for SAE 1020, SAE 1215, and OFHC Cu of standard 12.8 mm (0.505 in.) dia test bars. The tension test was interrupted at predetermined intervals in order to remove excess material from the gage sections after necking had commenced, or to subject the gage sections to a drawing operation in order to keep the difference between the neck diameters and the gage section diameter as small as possible for the purpose of reducing the triaxiality of the stresses in the necked region. The tests showed that the triaxiality could be reduced for SAE 1215 and OFHC Cu by machining the gage section. However, as expected and shown for one series of tests with ETPC Cu, the drawing operations were more effective because of work hardening of the gage sections.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Modified Tension Test
dc.typeJournal Paper
dc.journal.volume99
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3443528
dc.journal.fristpage252
dc.journal.lastpage256
dc.identifier.eissn1528-8889
dc.keywordsTension
dc.keywordsGages
dc.keywordsStress
dc.keywordsNecking
dc.keywordsWork hardening AND Machining
dc.treeJournal of Engineering Materials and Technology:;1977:;volume( 099 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record