Show simple item record

dc.contributor.authorR. O. Ritchie
dc.date.accessioned2017-05-08T23:02:53Z
dc.date.available2017-05-08T23:02:53Z
dc.date.copyrightJuly, 1977
dc.date.issued1977
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26855#195_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/89887
dc.description.abstractFatigue crack propagation behavior of an ultra-high strength steel (300-M) has been investigated in humid air over a very wide spectrum of growth rates from 10−8 to 10−1 mm/cycle. Particular emphasis has been devoted to the influence of mean stress (or load ratio R = Kmin /Kmax ) and microstructure on fatigue crack growth near the threshold stress intensity for crack propagation, ΔK0 . Increasing the load ratio from R = 0.05 to 0.70 was found to lead to increased near-threshold growth rates, and a decrease in the threshold stress intensity. Similarly, increasing material strength, by varying the microstructure through quench and tempering and isothermal transformation, resulted in higher near-threshold growth rates, and a marked reduction of ΔK0 . These effects are contrasted with behavior at higher growth rates. The influence of strength on ΔK0 is rationalized in terms of the cyclic hardening or softening response of the material, and hence it is shown that cyclic softening can be beneficial to fatigue crack propagation resistance at very low growth rates. The results are discussed in the light of crack closure and environmental contributions to fatigue crack growth at low stress intensities.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleNear-Threshold Fatigue Crack Propagation in Ultra-High Strength Steel: Influence of Load Ratio and Cyclic Strength
dc.typeJournal Paper
dc.journal.volume99
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3443519
dc.journal.fristpage195
dc.journal.lastpage204
dc.identifier.eissn1528-8889
dc.keywordsStress
dc.keywordsSteel
dc.keywordsFatigue cracks
dc.keywordsSpectra (Spectroscopy)
dc.keywordsElectrical resistance
dc.keywordsStrength (Materials)
dc.keywordsHardening
dc.keywordsFracture (Materials)
dc.keywordsCrack propagation AND Cycles
dc.treeJournal of Engineering Materials and Technology:;1977:;volume( 099 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record