Show simple item record

dc.contributor.authorC. W. Bert
dc.date.accessioned2017-05-08T23:02:52Z
dc.date.available2017-05-08T23:02:52Z
dc.date.copyrightOctober, 1977
dc.date.issued1977
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26857#344_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/89869
dc.description.abstractIt has been observed that certain filamentary composite materials exhibit a different Poisson compliance when loaded transversely to the fibers than when loaded longitudinally (parallel to the fibers). In such cases the following widely used reciprocal relation is not satisfied: νLT/EL = νLT/ET where EL and ET are the L (longitudinal) and T (transverse) Young’s moduli and νLT and νTL are the Poisson’s ratios obtained from uniaxial loading in the L and T directions. Here two entirely different approaches are used to develop mathematical models of an elastic composite material behaving as described above. One method permits the compliance matrix to be unsymmetric but vary smoothly with the angular orientation. The other method, which is believed to be more valid, incorporates one set of symmetric compliances when the fibers are loaded in tension and a different set of symmetric compliances when the fibers are loaded in compression. The two different models are applied to some data for rubber reinforced by aramid (Kevlar) cord. For this composite, the above reciprocal relation is least satisfied, since νTL /ET is approximately 147 times νLT /EL .
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleModels for Fibrous Composites With Different Properties in Tension and Compression
dc.typeJournal Paper
dc.journal.volume99
dc.journal.issue4
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3443550
dc.journal.fristpage344
dc.journal.lastpage349
dc.identifier.eissn1528-8889
dc.keywordsFiber reinforced composites
dc.keywordsCompression
dc.keywordsTension
dc.keywordsFibers
dc.keywordsComposite materials AND Rubber
dc.treeJournal of Engineering Materials and Technology:;1977:;volume( 099 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record