Show simple item record

dc.contributor.authorP. Shahinian
dc.date.accessioned2017-05-08T23:01:42Z
dc.date.available2017-05-08T23:01:42Z
dc.date.copyrightMay, 1976
dc.date.issued1976
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28131#166_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/89208
dc.description.abstractThe inclusion of tensile hold periods during cyclic loading did not detrimentally affect rate of crack propagation in solution-annealed type 304 steel and 20 percent cold-worked type 316 steel at 427 C (800 F). But at 593 C (1100 F), increases in hold time caused higher crack growth rates (da/dN), for a given stress intensity factor range (ΔK ), for both steels. In terms of da/dt, hold periods decreased growth rates for the type 304 steel. The number of cycles to failure of the type 304 steel decreased and the time to failure increased with increasing hold times; but the trends were not the same for the type 316 steel. Hold periods caused a shift in cracking mode from transgranular to intergranular.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleCreep-Fatigue Crack Propagation in Austenitic Stainless Steel
dc.typeJournal Paper
dc.journal.volume98
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3454355
dc.journal.fristpage166
dc.journal.lastpage172
dc.identifier.eissn1528-8978
dc.keywordsCreep
dc.keywordsFatigue
dc.keywordsCrack propagation
dc.keywordsStainless steel
dc.keywordsSteel
dc.keywordsFailure
dc.keywordsCycles
dc.keywordsStress
dc.keywordsFracture (Materials) AND Fracture (Process)
dc.treeJournal of Pressure Vessel Technology:;1976:;volume( 098 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record