Show simple item record

dc.contributor.authorR. C. Gwaltney
dc.contributor.authorJ. M. Corum
dc.contributor.authorS. E. Bolt
dc.contributor.authorJ. W. Bryson
dc.date.accessioned2017-05-08T23:01:39Z
dc.date.available2017-05-08T23:01:39Z
dc.date.copyrightNovember, 1976
dc.date.issued1976
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28139#283_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/89179
dc.description.abstractFour carefully machined cylinder-to-cylinder shell models were tested, and the experimentally determined stresses were compared with theoretical predictions obtained from a thin-shell finite-element analysis. The models were idealized structures consisting of two circular cylindrical shells intersecting at right angles. The first model tested had a nozzle-to-cylinder diameter ratio of 0.5 and a diameter-to-thickness of 100 for both nozzle and cylinder. The second model had a nozzle-to-cylinder diameter ratio of 1.0 with a diameter-to-thickness ratio of 100. The third and fourth models had a nozzle-to-cylinder ratio of 0.129. For these models the diameter-to-thickness ratio was 50 for the cylinders and 7.68 for the nozzle of model 3, while it was 20.2 for the nozzle of model 4. All models were strain gaged and subjected to 13 separate loading cases. Comparisons of measured and predicted stress distributions are presented for three of these loadings—internal pressure and in-plane and out-of-plane moments applied to the nozzle. The analytical predictions were obtained using a finite-element program that used flat-plate elements and which considered five degrees of freedom per node in the final assembled equations. The agreement between these particular finite-element predictions and the experimental results is shown to be reasonably good for the four models.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleExperimental Stress Analysis of Cylinder-to-Cylinder Shell Models and Comparisons With Theoretical Predictions
dc.typeJournal Paper
dc.journal.volume98
dc.journal.issue4
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3454413
dc.journal.fristpage283
dc.journal.lastpage290
dc.identifier.eissn1528-8978
dc.keywordsStress analysis (Engineering)
dc.keywordsCylinders
dc.keywordsShells
dc.keywordsNozzles
dc.keywordsThickness
dc.keywordsFinite element analysis
dc.keywordsStress
dc.keywordsPressure
dc.keywordsDegrees of freedom
dc.keywordsCircular cylindrical shells
dc.keywordsEquations
dc.keywordsFlat plates AND Thin shells
dc.treeJournal of Pressure Vessel Technology:;1976:;volume( 098 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record