Show simple item record

dc.contributor.authorJ. C. Thompson
dc.contributor.authorJ. C. Jofriet
dc.contributor.authorY. Sze
dc.contributor.authorD. G. Strevel
dc.date.accessioned2017-05-08T23:01:38Z
dc.date.available2017-05-08T23:01:38Z
dc.date.copyrightNovember, 1976
dc.date.issued1976
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28139#277_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/89178
dc.description.abstractIn most bolted connections, the unknown interface pressure distribution and the extent of the contact region are essential parameters in any stress analysis. Concerning these parameters, experimental and numerical studies of a model of an isolated single-bolt region show the following. The contact region between the flanges depends almost exclusively on the ratio of the flange thickness to the diameter of the surface region of each flange over which the bolt prestressing force is distributed; the contact zone is virtually independent of both the level of prestressing force and of the size of the bolt hole; and the contact stress distribution for a typical range of parameters is very closely approximated by a truncated conical distribution. The studies also delineate the regions of the flanges around each bolt where the stress state is strongly three-dimensional and regions where simple plate theory is applicable. The relationships established between the contact stress distribution and the various geometric parameters are presented in a form immediately applicable by designers.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Interface Boundary Conditions for Bolted Flanged Connections
dc.typeJournal Paper
dc.journal.volume98
dc.journal.issue4
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3454412
dc.journal.fristpage277
dc.journal.lastpage282
dc.identifier.eissn1528-8978
dc.keywordsForce
dc.keywordsPressure
dc.keywordsStress
dc.keywordsStress analysis (Engineering)
dc.keywordsStress concentration
dc.keywordsFlanges
dc.keywordsBoundary-value problems
dc.keywordsFlange connections AND Thickness
dc.treeJournal of Pressure Vessel Technology:;1976:;volume( 098 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record