Show simple item record

dc.contributor.authorJ. H. Gittus
dc.date.accessioned2017-05-08T23:00:48Z
dc.date.available2017-05-08T23:00:48Z
dc.date.copyrightJanuary, 1976
dc.date.issued1976
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26844#52_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/88693
dc.description.abstractFurther analysis of a model in which creep is attributed to the movement generation, immobilization, and recovery of dislocations has permitted the anelastic (recoverable) component of strain to be calculated. The earlier conclusions are unaffected by this refinement and so the model equations continue correctly to predict the effects of raising, reducing, removing and reversing the stress during the creep of a range of materials including stainless steel, zirconium alloys, copper, tungsten, nickel, and aluminum. In addition, however, it is now (correctly) predicted that removal of a tensile stress will permit compressive creep to occur, producing an anelastic strain whose magnitude increases towards an upper asymptote as the magnitude of the prior tensile stress increases. Anelasticity is found to become an increasingly large proportion of the total strain at low stresses: the model predicts this. It also predicts the pattern of behavior observed in “stress-dip” tests: in particular that there is a critical magnitude of stress reduction which causes momentary cessation of creep.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleDevelopment of Constitutive Relation for Plastic Deformation From a Dislocation Model
dc.typeJournal Paper
dc.journal.volume98
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3443337
dc.journal.fristpage52
dc.journal.lastpage59
dc.identifier.eissn1528-8889
dc.keywordsDeformation
dc.keywordsDislocations
dc.keywordsCreep
dc.keywordsStress
dc.keywordsTension
dc.keywordsTungsten
dc.keywordsZirconium alloys
dc.keywordsEquations
dc.keywordsStainless steel
dc.keywordsCopper
dc.keywordsAluminum AND Nickel
dc.treeJournal of Engineering Materials and Technology:;1976:;volume( 098 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record