Show simple item record

dc.contributor.authorF. A. Simonen
dc.contributor.authorK. Specht
dc.contributor.authorN. C. Henderson
dc.contributor.authorR. D. Winegardner
dc.date.accessioned2017-05-08T22:59:36Z
dc.date.available2017-05-08T22:59:36Z
dc.date.copyrightAugust, 1975
dc.date.issued1975
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28120#192_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/88006
dc.description.abstractThis paper describes a study of aluminum gas cylinders used in underwater manned vehicles. A determination was made of the relative increase in one cycle burst pressure and fatigue life of an existing aluminum gas cylinder when the sidewall was reinforced with fiberglass overwrap and prestressed by over pressurization. Detailed finite-element stress analyses were conducted to determine the operating stresses and also the residual stresses at the end cap-to-cylinder transition section which were a result of plastic deformation during proof testing. Calculated residual stresses were found to be consistent with experimental measurements. It was determined that the filament reinforcement both increased the vessel burst pressure and increased the vessel fatigue life through favorable prestress effects. Results of vessel fatigue and burst tests are presented and are compared with the predicted performance characteristics.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAnalysis of Strength and Residual Stresses in Filament Reinforced Aluminum Cylinders
dc.typeJournal Paper
dc.journal.volume97
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3454294
dc.journal.fristpage192
dc.journal.lastpage198
dc.identifier.eissn1528-8978
dc.keywordsResidual stresses
dc.keywordsAluminum
dc.keywordsCylinders
dc.keywordsVessels
dc.keywordsGas cylinders
dc.keywordsFatigue life
dc.keywordsPressure
dc.keywordsDeformation
dc.keywordsFatigue
dc.keywordsMeasurement
dc.keywordsPerformance characterization
dc.keywordsGlass reinforced plastics
dc.keywordsStress
dc.keywordsStress analysis (Engineering)
dc.keywordsFinite element analysis
dc.keywordsTesting
dc.keywordsVehicles AND Cycles
dc.treeJournal of Pressure Vessel Technology:;1975:;volume( 097 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record