Show simple item record

dc.contributor.authorG. Bartholome
dc.contributor.authorG. Vasoukis
dc.date.accessioned2017-05-08T22:59:35Z
dc.date.available2017-05-08T22:59:35Z
dc.date.copyrightNovember, 1975
dc.date.issued1975
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28122#315_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/87997
dc.description.abstractThe judgment of welds with defects in reactor components is done by nondestructive as well as destructive material testing, stress analysis, and fracture mechanics. The following investigations are required: The kind, position, and size of defects in welds (stress relief cracks, hot tearing) is determined through nondestructive and destructive material testing. Strength, toughness, and subcritical crack-growth data are measured for weld-material, heat-affected zone and base material. The determination of strength, toughness, and subcritical crack growth of the heat-affected zone is very difficult, because the heat-affected zone is small and irregulary distributed. Therefore the heat-affected zone is simulated through suitable heat treatment. From this it is possible to estimate the behavior of original welds. Through the defect, material, and stress data the safety of welds with defects is proved. Additionally the margin of this safety is determined. The experimental verification of the calculations is done through a pulsating test of model under original loading conditions, including all specified loads.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAnalysis of Defects in Welds
dc.typeJournal Paper
dc.journal.volume97
dc.journal.issue4
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3454313
dc.journal.fristpage315
dc.journal.lastpage320
dc.identifier.eissn1528-8978
dc.keywordsProduct quality
dc.keywordsWelded joints
dc.keywordsHeat
dc.keywordsFracture (Materials)
dc.keywordsStress
dc.keywordsToughness
dc.keywordsSafety
dc.keywordsMaterials testing
dc.keywordsHeat treating (Metalworking)
dc.keywordsStress analysis (Engineering) AND Fracture mechanics
dc.treeJournal of Pressure Vessel Technology:;1975:;volume( 097 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record