Show simple item record

dc.contributor.authorI. Berman
dc.contributor.authorR. Henschel
dc.date.accessioned2017-05-08T22:59:34Z
dc.date.available2017-05-08T22:59:34Z
dc.date.copyrightNovember, 1975
dc.date.issued1975
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28122#264_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/87989
dc.description.abstractOne thousand-hr beam bending creep tests at 1000° F (537.7° C) on four, one-in. (25.4-mm) deep stainless steel specimens of seven-in. gage length with constant end moment were run. The specimens included: two of all weld metal, one of base metal and one bimetallic beam. The short time and creep bending results are compared to the results of a finite element analysis in which book values are used. The experimental results indicate some significant differences in short time properties and primary creep. The analytical results substantially underestimate the primary creep.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleCreep Bending Tests of Large Weld Overlay and Base Metal Specimens at 1000°F (537.7°C)
dc.typeJournal Paper
dc.journal.volume97
dc.journal.issue4
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3454306
dc.journal.fristpage264
dc.journal.lastpage269
dc.identifier.eissn1528-8978
dc.keywordsOverlays (Materials engineering)
dc.keywordsBase metals
dc.keywordsCreep
dc.keywordsMetals
dc.keywordsGages
dc.keywordsFinite element analysis AND Stainless steel
dc.treeJournal of Pressure Vessel Technology:;1975:;volume( 097 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record