Show simple item record

dc.contributor.authorD. M. Turley
dc.date.accessioned2017-05-08T22:58:44Z
dc.date.available2017-05-08T22:58:44Z
dc.date.copyrightJanuary, 1975
dc.date.issued1975
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26839#21_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/87547
dc.description.abstractThe surface finishes produced by taper reaming of holes in a composite structure of aluminum alloy and ultra-high strength steel are examined for both dry and lubricated cutting conditions. In dry reaming cutting occurred under built-up-edge (BUE) conditions whereas when a mineral cutting oil was used no significant BUE was formed. Reaming under the latter conditions resulted in a more undulating steel surface finish but a much smoother surface finish for the aluminum alloy.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleSurface Finishes Produced by Tungsten Carbide Taper Pin Reamers
dc.typeJournal Paper
dc.journal.volume97
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3443255
dc.journal.fristpage21
dc.journal.lastpage24
dc.identifier.eissn1528-8889
dc.keywordsFinishes
dc.keywordsTungsten
dc.keywordsCutting
dc.keywordsSteel
dc.keywordsAluminum alloys AND Composite materials
dc.treeJournal of Engineering Materials and Technology:;1975:;volume( 097 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record