Show simple item record

dc.contributor.authorR. G. Davies
dc.contributor.authorC. L. Magee
dc.date.accessioned2017-05-08T22:58:43Z
dc.date.available2017-05-08T22:58:43Z
dc.date.copyrightApril, 1975
dc.date.issued1975
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26840#151_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/87534
dc.description.abstractThe tensile strength of seventeen engineering materials including steels, Al alloys, and fiber-reinforced plastics, has been determined at strain-rates from 10−3 to 103 sec−1 . Variable effects on the stress-strain behavior were found in the different materials with the Al alloys showing minimal strain-rate sensitivity and the plastics highest. All results exhibit a logarithmic dependence of flow stress on strain-rate and thus the dynamic factors (ratio of dynamic to low rate or quasi-static strengths) are as dependent upon changes in quasi-static testing speed (∼1 in./min (0.42 mm/s) as they are to changes at high speed (50,000 in./min or 50 mph (22.35 m/s). No significant influence of strain-rate on elongation or reduction in area has been found for any of the materials. Steels, which comprise the majority of the presently investigated materials, exhibit a higher rate sensitivity for yielding than for higher strain deformation. It is shown that the flow stress results for these steels leads to an internally consistent scheme when (1) strength level and (2) strengthening mechanisms are properly accounted for.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Effect of Strain-Rate Upon the Tensile Deformation of Materials
dc.typeJournal Paper
dc.journal.volume97
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3443275
dc.journal.fristpage151
dc.journal.lastpage155
dc.identifier.eissn1528-8889
dc.keywordsDeformation
dc.keywordsSteel
dc.keywordsStress
dc.keywordsAluminum alloys
dc.keywordsFlow (Dynamics)
dc.keywordsTesting
dc.keywordsElongation
dc.keywordsFiber reinforced plastics
dc.keywordsTensile strength
dc.keywordsPlastics AND Mechanisms
dc.treeJournal of Engineering Materials and Technology:;1975:;volume( 097 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record