Show simple item record

dc.contributor.authorG. W. Vickers
dc.contributor.authorA. Plumtree
dc.contributor.authorR. Sowerby
dc.contributor.authorJ. L. Duncan
dc.date.accessioned2017-05-08T22:58:43Z
dc.date.available2017-05-08T22:58:43Z
dc.date.copyrightApril, 1975
dc.date.issued1975
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26840#126_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/87531
dc.description.abstractPlasticine, Commercially Pure Lead and 6061T6 Aluminum have been used as model materials to simulate some of the forming processes that can arise during a first blow axisymmetric heading operation namely; upsetting, forming into a die cavity and the free flow operation. The deformation characteristics have been studied in each of these operations and some gross internal flow patterns have been determined using multilayer plasticine workpieces. The influence of both the operation and the workpiece geometry on the heading forces was also investigated. Some simple analytical models based mainly on the Load Bounding Techniques have been employed to predict the heading forces. Reasonable agreement was observed between the theoretical and experimental results.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleSimulation of the Heading Process
dc.typeJournal Paper
dc.journal.volume97
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3443272
dc.journal.fristpage126
dc.journal.lastpage135
dc.identifier.eissn1528-8889
dc.keywordsForce
dc.keywordsFlow (Dynamics)
dc.keywordsDeformation
dc.keywordsAluminum
dc.keywordsSimulation
dc.keywordsStress
dc.keywordsInternal flow
dc.keywordsCavities AND Geometry
dc.treeJournal of Engineering Materials and Technology:;1975:;volume( 097 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record