Show simple item record

dc.contributor.authorC. Rubin
dc.date.accessioned2017-05-08T22:58:40Z
dc.date.available2017-05-08T22:58:40Z
dc.date.copyrightOctober, 1975
dc.date.issued1975
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26843#363_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/87505
dc.description.abstractThe bending of a circular corrugated diaphragm which is clamped along its outer edge and clamped to a shaft at its geometric center is analyzed. The shaft may undergo small axial displacements or small angular displacements in a plane perpendicular to the plane of the original plate surface. The diaphragm is treated as a polar-orthotropic plate and closed form solutions are obtained for the deflection and stresses at any point for cases with and without a uniform load acting on the diaphragm surface. Maximum deflections and stresses are located and optimum inner-to-outer diameter ratios are determined.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleOptimum Design for a Corrugated Diaphragm Clamped to a Shaft Undergoing Axial or Angular Displacement
dc.typeJournal Paper
dc.journal.volume97
dc.journal.issue4
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3443312
dc.journal.fristpage363
dc.journal.lastpage366
dc.identifier.eissn1528-8889
dc.keywordsDiaphragms (Structural)
dc.keywordsDesign
dc.keywordsDisplacement
dc.keywordsStress AND Deflection
dc.treeJournal of Engineering Materials and Technology:;1975:;volume( 097 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record