Show simple item record

dc.contributor.authorA. F. Amin
dc.contributor.authorS. I. Wiraguna
dc.contributor.authorA. R. Bhuiyan
dc.contributor.authorY. Okui
dc.date.accessioned2017-05-08T22:40:44Z
dc.date.available2017-05-08T22:40:44Z
dc.date.copyrightJanuary 2006
dc.date.issued2006
dc.identifier.other%28asce%290733-9399%282006%29132%3A1%2854%29.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/86153
dc.description.abstractRate-independent monotonic behavior of filled natural rubber and high damping rubber is investigated in compression and shear regimes. Monotonic responses obtained from tests conducted in both regimes demonstrate the prominent existence of the Fletcher–Gent effect, indicated by high stiffness at low strain levels. An improved hyperelasticity model for compression and shear regimes is proposed to represent the rate-independent instantaneous and equilibrium responses including the Fletcher–Gent effect. A parameter identification scheme involving simultaneous minimization of least-square residuals of uniaxial compression and simple shear data is delineated. The difficulties of identifying a unique set of hyperelasticity parameters that hold for both compression and shear deformation modes are thus overcome. The proposed hyperelasticity model has been implemented in a general purpose finite element program. Finite element simulations of experiments have shown the adequacy of the proposed hyperelasticity model, estimated parameters, and employed numerical procedures. Finally, numerical experiments were conducted to further explore the potential of the proposed model, and estimated parameters in analyzing rubber layers of a base isolation bearing subjected either to compression or to a combination of compression and shear.
dc.publisherAmerican Society of Civil Engineers
dc.titleHyperelasticity Model for Finite Element Analysis of Natural and High Damping Rubbers in Compression and Shear
dc.typeJournal Paper
dc.journal.volume132
dc.journal.issue1
dc.journal.titleJournal of Engineering Mechanics
dc.identifier.doi10.1061/(ASCE)0733-9399(2006)132:1(54)
dc.treeJournal of Engineering Mechanics:;2006:;Volume ( 132 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record