Show simple item record

dc.contributor.authorJ. Dario Aristizabal-Ochoa
dc.date.accessioned2017-05-08T22:40:37Z
dc.date.available2017-05-08T22:40:37Z
dc.date.copyrightMay 2005
dc.date.issued2005
dc.identifier.other%28asce%290733-9399%282005%29131%3A5%28473%29.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/86087
dc.description.abstractStability criteria that evaluate the effects of combined conservative and nonconservative end axial forces on the elastic divergence buckling load of prismatic beam-columns with semirigid connections is presented using the classic static equilibrium method. The proposed method and stability equations follow the same format and classification of ideal beam-columns under gravity loads presented previously by Aristizabal-Ochoa in 1996 and 1997. Criterion is also given to determine the minimum lateral bracing required by beam-columns with semirigid connections to achieve “braced” buckling (i.e., with sidesway inhibited). Analytical results obtained from three cases of cantilever columns presented in this paper indicate that: (1) the proposed method captures the limit on the range of applicability of the Euler’s method in the stability analysis of beam-columns subjected to simultaneous combinations of conservative and nonconservative loads. The static method as proposed herein can give the correct solution to the stability of beam-columns within a wide range of combinations of conservative and nonconservative axial loads without the need to investigate their small oscillation behavior about the equilibrium position; and (2) dynamic instability or flutter starts to take place when the static critical loads corresponding to the first and second mode of buckling of the column become identical to each other. “Flutter” in these examples is caused by the presence of nonconservative axial forces (tension or compression) and the softening of both the flexural restraints and the lateral bracing. In addition, the “transition” from static instability (with sidesway and critical zero frequency) to dynamic instability (with no sidesway or purely imaginary sidesway frequencies) was determined using static equilibrium. It was found also that the static critical load under braced conditions (i.e., with sidesway inhibited) is the upper bound of the dynamic buckling load of a cantilever column under nonconservative compressive forces. Analytical studies indicate the buckling load of a beam-column is not only a function of the degrees of fixity (
dc.publisherAmerican Society of Civil Engineers
dc.titleStatic Stability of Beam-Columns under Combined Conservative and Nonconservative End Forces: Effects of Semirigid Connections
dc.typeJournal Paper
dc.journal.volume131
dc.journal.issue5
dc.journal.titleJournal of Engineering Mechanics
dc.identifier.doi10.1061/(ASCE)0733-9399(2005)131:5(473)
dc.treeJournal of Engineering Mechanics:;2005:;Volume ( 131 ):;issue: 005
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record