Show simple item record

dc.contributor.authorLaurent Lancelot
dc.contributor.authorIsam Shahrour
dc.contributor.authorMarwan Al Mahmoud
dc.date.accessioned2017-05-08T22:40:18Z
dc.date.available2017-05-08T22:40:18Z
dc.date.copyrightNovember 2004
dc.date.issued2004
dc.identifier.other%28asce%290733-9399%282004%29130%3A11%281365%29.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/85848
dc.description.abstractThe behavior of Hostun RF sand on proportional strain paths at low confining pressures (20 to 100 kPa) is considered in this paper. In such paths, a constant dilation rate is imposed during shear. The usual features of pore pressure increase (contracting material) or decrease (dilating material) are here observed depending upon whether the imposed dilation rate is respectively greater or smaller than the “natural” dilation rate at failure (as measured in a drained test). Particular attention is given to the static liquefaction phenomenon, which is seen to occur for loose as well as dense sand provided the imposed dilation rate is large enough to lead to a continuous pore pressure increase during shear. Instability tests performed at low confining pressures on proportional strain paths show that the instability line is strain path dependent. It does not coincide with the peak deviator stress line in proportional strain paths tests, in general, but does coincide with the line
dc.publisherAmerican Society of Civil Engineers
dc.titleInstability and Static Liquefaction on Proportional Strain Paths for Sand at Low Stresses
dc.typeJournal Paper
dc.journal.volume130
dc.journal.issue11
dc.journal.titleJournal of Engineering Mechanics
dc.identifier.doi10.1061/(ASCE)0733-9399(2004)130:11(1365)
dc.treeJournal of Engineering Mechanics:;2004:;Volume ( 130 ):;issue: 011
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record