• Login
    View Item 
    •   DSpace Home
    • ASCE
    • Journal of Engineering Mechanics
    • View Item
    •   DSpace Home
    • ASCE
    • Journal of Engineering Mechanics
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Experimental Methods for Estimating In Situ Tensile Force in Tie-Rods

    Thumbnail
    View/Open
    %28asce%290733-9399%282001%29127%3A12%281275%29.pdf (140.0Kb)
    Date
    2001
    Author
    Silvia Briccoli Bati
    Ugo Tonietti
    Metadata
    Show full item record
    Abstract
    Several methods have been proposed for estimating the actual tensile forces in metallic tie-rods inserted into the masonry arches and vaults of historic buildings. Static and dynamic methods based on the experimental measurement of the vertical displacements caused by concentrated loads, accelerations, and the fundamental frequencies and periods of free vibrations have been applied to arrive at a more precise evaluation of the axial tensile forces acting on the tie-rod under examination. Each of these methods, with its corresponding experimental procedure, presents different advantages and disadvantages with regard to operating procedures, equipment requirements, and accuracy range in the determination of tie-rod stress. In this paper the writers propose a simple method and experimental procedure based on a single static test. The reference structural system consists of a bending moment-resistant tie beam with unknown restraint conditions at its ends. Therefore, the proposed method does not require any assumptions when modeling the rod's extremities, nor does it discount the increase in pull induced by the transverse load as irrelevant. The relevant experimental data are represented by three vertical displacements under a concentrated load and the strain variations measured in three sections of the rod. The reliability of the method has been verified through laboratory tests using tie-rods set within a sufficiently stiff metal framework in which the tension is known through continuous monitoring by means of a load cell. The correlation of the measurements with the actual tensile strength was checked; laboratory tests show good agreement between the analytical estimates and experimental measurements.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/85319
    Collections
    • Journal of Engineering Mechanics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV