Show simple item record

dc.contributor.authorKangmin Niu
dc.contributor.authorRamesh Talreja
dc.date.accessioned2017-05-08T22:39:00Z
dc.date.available2017-05-08T22:39:00Z
dc.date.copyrightAugust 1999
dc.date.issued1999
dc.identifier.other%28asce%290733-9399%281999%29125%3A8%28875%29.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/85039
dc.description.abstractA wrinkling model for sandwich panels in compression is developed with the assumption of a continuous isotropic linear elastic core. Wrinkling stresses for the three modes, defined in a well-known book by H. G. Allen, are expressed by a unified, single expression. The expression depends linearly on a case parameter η, defined to specify the three cases of wrinkling: η = 0 for single-sided face wrinkling (case 1), η = 1 for in-phase wrinkling (case 2), and η = −1 for out-of-phase wrinkling (case 3). It is shown that the stresses in all three cases are almost identical for short wavelength wrinkling and can be expressed by a single simplified analytical expression; however, they may differ significantly in moderate and long wavelength wrinkling, and for these cases they are given by simplified analytical expressions. It is proved that the in-phase wrinkling stress is the lowest among the three cases. Based on the analysis conducted, limitations of the commonly used Winkler and two-parameter models are discussed. Finally, engineering design procedures are recommended for the wrinkling effect in sandwich panels under compression.
dc.publisherAmerican Society of Civil Engineers
dc.titleModeling of Wrinkling in Sandwich Panels under Compression
dc.typeJournal Paper
dc.journal.volume125
dc.journal.issue8
dc.journal.titleJournal of Engineering Mechanics
dc.identifier.doi10.1061/(ASCE)0733-9399(1999)125:8(875)
dc.treeJournal of Engineering Mechanics:;1999:;Volume ( 125 ):;issue: 008
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record