Show simple item record

dc.contributor.authorNorio Hasebe
dc.contributor.authorKiyotaka Kojima
dc.contributor.authorJun Qian
dc.date.accessioned2017-05-08T22:38:52Z
dc.date.available2017-05-08T22:38:52Z
dc.date.copyrightMarch 1999
dc.date.issued1999
dc.identifier.other%28asce%290733-9399%281999%29125%3A3%28300%29.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/84953
dc.description.abstractFlat-ended or wedge-shaped rigid punch problem is considered in this paper. The punch is with one end sliding and the other end with a sharp corner coming into a half-plane. The model of the punch is that the flat-end punch is inclined by an angle ε or the wedge-shaped punch with ε is pushed vertically. A crack is assumed to be initiated from the end with the corner, and Coulomb's frictional force exists on the contact region. The general solution of the problem is derived in an analytical way, and the relation among the vertical load on the punch, rotating angle of the punch, and the contact length is found. Stress intensity factors of the edge crack are calculated in different cases. The resultant moments at the origin of the coordinates are also calculated, which can be used to decide the position of the vertical force on the punch.
dc.publisherAmerican Society of Civil Engineers
dc.titleIncomplete Frictional Flat-Ended Punch on Half-Plane with Edge Crack
dc.typeJournal Paper
dc.journal.volume125
dc.journal.issue3
dc.journal.titleJournal of Engineering Mechanics
dc.identifier.doi10.1061/(ASCE)0733-9399(1999)125:3(300)
dc.treeJournal of Engineering Mechanics:;1999:;Volume ( 125 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record