Show simple item record

dc.contributor.authorPeter H. Bischoff
dc.contributor.authorSimon H. Perry
dc.date.accessioned2017-05-08T22:37:37Z
dc.date.available2017-05-08T22:37:37Z
dc.date.copyrightJune 1995
dc.date.issued1995
dc.identifier.other%28asce%290733-9399%281995%29121%3A6%28685%29.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/84244
dc.description.abstractThe uniaxial stress-strain response has been measured for air-dried plain-concrete cylinders, nominally 100 mm in diameter and 250 mm long, loaded in compression at both a slow static rate of about 10 microstrains per second and a much higher impact rate of between 5 and 10 strains per second. Design concrete strengths of 30 and 50 MPa were tested. Static loading was carried out in a hydraulic testing machine, and a guided free-falling mass was used for impact loading. The impact and static responses are compared to provide some insight into the behavior of concrete during hard-impact loading. Differences in behavior are identified for various strength and deformation characteristics. Although the maximum strength and corresponding axial strain, the energy-absorption capacity at failure, and the secant modulus all increase during impact loading, the initial tangent modulus does not appear to change very much. Other characteristics such as volumetric strain and Poisson's ratio are also studied. A simple physical model is used to help explain observed changes.
dc.publisherAmerican Society of Civil Engineers
dc.titleImpact Behavior of Plain Concrete Loaded in Uniaxial Compression
dc.typeJournal Paper
dc.journal.volume121
dc.journal.issue6
dc.journal.titleJournal of Engineering Mechanics
dc.identifier.doi10.1061/(ASCE)0733-9399(1995)121:6(685)
dc.treeJournal of Engineering Mechanics:;1995:;Volume ( 121 ):;issue: 006
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record