Show simple item record

dc.contributor.authorJulian Wolfram
dc.date.accessioned2017-05-08T22:37:34Z
dc.date.available2017-05-08T22:37:34Z
dc.date.copyrightMarch 1995
dc.date.issued1995
dc.identifier.other%28asce%290733-9399%281995%29121%3A3%28472%29.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/84215
dc.description.abstractThis technical note shows that the injudicious addition of area to the cross secion of a beam in bending may reduce the minimum elastic section modulus. Simple expressions are derived, which give the locations within a section where this occurs. For initially symmetrical standard beam sections these locations extend from the neutral axis for distances of between 12% of the section depth for round bars, to 35% for I-beams. An expression is derived for the location at which any added area will give the maximum reduction in minimum section modulus and another expression from which the magnitude of this maximum reduction may be calculated. The theoretical worst case is an idealized I-beam with a negligible web area for which any added area except at the neutral axis or flanges will reduce the section modulus; and the theoretically possible maximum reduction is 16.7%, corresponding with a 20% increase in stress. The results obtained in this paper should be particularly useful in the design of built-up sections such as box-girder bridges, aircrafts, and ship hulls in which fatigue and/or fracture may be a limiting constraint.
dc.publisherAmerican Society of Civil Engineers
dc.titleReducing Section Modulus of Beams by Adding Cross-Sectional Area
dc.typeJournal Paper
dc.journal.volume121
dc.journal.issue3
dc.journal.titleJournal of Engineering Mechanics
dc.identifier.doi10.1061/(ASCE)0733-9399(1995)121:3(472)
dc.treeJournal of Engineering Mechanics:;1995:;Volume ( 121 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record