Show simple item record

dc.contributor.authorE. Gutierrez
dc.contributor.authorG. Magonette
dc.contributor.authorG. Verzeletti
dc.date.accessioned2017-05-08T22:36:57Z
dc.date.available2017-05-08T22:36:57Z
dc.date.copyrightMay 1993
dc.date.issued1993
dc.identifier.other%28asce%290733-9399%281993%29119%3A5%28887%29.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/83892
dc.description.abstractThis paper presents a testing technique to evaluate the effect of loading frequency on the behavior of structural elements. This single‐specimen technique consists in subjecting a specimen to two loading rates, but shifting, at the end of each cycle, from one frequency to the other. The writers found that by subjecting single specimens to alternate frequency loading cycles, the rate effect may be observed more clearly than by comparing the behavior of different specimens, each loaded at one of the prescribed frequencies. This is because when using a multispecimen technique, the results are prone to scatter inherent in the material properties; in particular, it would seem that when testing reinforced concrete (RC) specimens, the rate‐of‐loading effect may be of the same order of magnitude as the scatter, which is not the case when a single specimen is used. The alternate frequency technique was applied to
dc.publisherAmerican Society of Civil Engineers
dc.titleExperimental Studies of Loading Rate Effects on Reinforced Concrete Columns
dc.typeJournal Paper
dc.journal.volume119
dc.journal.issue5
dc.journal.titleJournal of Engineering Mechanics
dc.identifier.doi10.1061/(ASCE)0733-9399(1993)119:5(887)
dc.treeJournal of Engineering Mechanics:;1993:;Volume ( 119 ):;issue: 005
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record