Show simple item record

dc.contributor.authorL. K. Seah
dc.contributor.authorJ. Rhodes
dc.date.accessioned2017-05-08T22:36:49Z
dc.date.available2017-05-08T22:36:49Z
dc.date.copyrightJanuary 1993
dc.date.issued1993
dc.identifier.other%28asce%290733-9399%281993%29119%3A1%2819%29.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/83785
dc.description.abstractTurning the free edge of the unstiffened flange inward or outward to form a lip, can substantially improve the local buckling resistance of a member, thus leading to greater efficiency. This is one of the most common edge stiffeners, used in cold‐rolled, thin‐walled sections. In the present paper, the behavior of plate elements stiffened by a compound edge (i.e. double‐fold lip) is examined both theoretically and experimentally. An outline of a series of tests on compound‐edge‐stiffened plate elements of various geometries is given and some load‐end compressive displacement paths are compared with the theoretical predictions. Reasonably good agreement is obtained between the experimental and theoretical results. Comparisons of the theoretical predictions with work done by other researchers are also presented in this paper.
dc.publisherAmerican Society of Civil Engineers
dc.titleSimplified Buckling Analysis of Plate with Compound Edge Stiffeners
dc.typeJournal Paper
dc.journal.volume119
dc.journal.issue1
dc.journal.titleJournal of Engineering Mechanics
dc.identifier.doi10.1061/(ASCE)0733-9399(1993)119:1(19)
dc.treeJournal of Engineering Mechanics:;1993:;Volume ( 119 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record