Show simple item record

dc.contributor.authorJeffrey A. Packer
dc.contributor.authorMin Sun
dc.contributor.authorKyle Tousignant
dc.date.accessioned2017-05-08T22:32:26Z
dc.date.available2017-05-08T22:32:26Z
dc.date.copyrightMay 2016
dc.date.issued2016
dc.identifier.other48927029.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/82270
dc.description.abstractThis paper discusses contemporary design procedures for fillet welds to hollow structural sections (HSS) in several prominent design codes. The structural reliability associated with the directional strength-enhancement factor contained in North American Specifications is examined, based on a set of laboratory tests on fillet-welded connections between HSS and rigid end-plates. A total of 33 connections, in which the welds had been designed to be the critical elements, were tested to failure by axial tension loading applied to the HSS members. The experimentally obtained weld strengths were compared to the predicted nominal strengths. The directional strength-enhancement factor was found to lead to unsafe strength predictions, particularly for large weld sizes. Hence, a restriction on the use of this factor for fillet welds to HSS members, in North American steel design specifications, needs to be considered. The analysis also shows that Eurocode 3 fillet weld design provisions give conservative strength predictions.
dc.publisherAmerican Society of Civil Engineers
dc.titleExperimental Evaluation of Design Procedures for Fillet Welds to Hollow Structural Sections
dc.typeJournal Paper
dc.journal.volume142
dc.journal.issue5
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)ST.1943-541X.0001467
dc.treeJournal of Structural Engineering:;2016:;Volume ( 142 ):;issue: 005
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record