Show simple item record

dc.contributor.authorR. Aithal
dc.contributor.authorG. Steven Gipson
dc.date.accessioned2017-05-08T22:28:29Z
dc.date.available2017-05-08T22:28:29Z
dc.date.copyrightJanuary 1990
dc.date.issued1990
dc.identifier.other%28asce%290733-9399%281990%29116%3A1%2877%29.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/81208
dc.description.abstractThe equation of motion of a fulid‐conveying pipe that includes the effect of damping is derived on the basis of Hamilton's principle. Depending upon the constraint conditions on the ends of the pipe, the induced or applied end forces may be classified as being either conservative or nonconservative. It is shown that when internal damping is taken into consideration, the conservative system could be subjected to a flutter type of instability. In certain cases, the capacity of the curved pipe to sustain flow is greatly affected by the internal damping factor. Under increasing fluid velocity, the pipes with an angle of bend less than 90° yield natural frquencies that do not follow the pattern of the pipe bends with angles of bend greater than 90°. Numerical results are presented for a wide range of parameters, including fluid velocity, damping parameter, and angle of the pipe bend.
dc.publisherAmerican Society of Civil Engineers
dc.titleInstability of Internally Damped Curved Pipes
dc.typeJournal Paper
dc.journal.volume116
dc.journal.issue1
dc.journal.titleJournal of Engineering Mechanics
dc.identifier.doi10.1061/(ASCE)0733-9399(1990)116:1(77)
dc.treeJournal of Engineering Mechanics:;1990:;Volume ( 116 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record