• Login
    View Item 
    •   DSpace Home
    • ASCE
    • Journal of Engineering Mechanics
    • View Item
    •   DSpace Home
    • ASCE
    • Journal of Engineering Mechanics
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Micromechanical Model and Associated Validation for Dynamic Failure of Brittle Materials Containing Pores and Slit-Like Flaws

    Thumbnail
    View/Open
    45870926.pdf (3.980Mb)
    Date
    2015
    Author
    Lori L. Graham-Brady
    Cynthia Zingale Katcoff
    Nathan P. Mayercsik
    Kimberly E. Kurtis
    Metadata
    Show full item record
    Abstract
    Characterizing dynamic failure is critically important to a number of applications, among others including armor, material fragmentation, and structural blast. In brittle materials, this failure is driven by crack growth from pre-existing flaws in the material microstructure. Structural scale models that explicitly address the cracks associated with each individual flaw are computationally infeasible; therefore, a model that accurately links flaw population to dynamic failure strength provides a much-needed connection between the microscale and macroscale. The current paper introduces a micromechanical model that addresses the effects of both air-entrained pores and slit-like flaws on the strain-rate dependent uniaxial compressive strength of the material. In particular, four variants of the model are addressed: a two-dimensional (2D) model with only pore flaws, a 2D model with both pores and slit-like flaws, a pseudo-three-dimensional (3D) model with only pore flaws, and a pseudo-3D model with both pores and slit-like flaws. To demonstrate the relative success of each of these approaches, the model is based on microstructural characterization and subsequent Kolsky bar tests on air-entrained mortar. Air-entrained mortar provides an excellent model material for this study, since the pore population introduced by air-entrainment is characterized relatively easily and the slit-like flaw population is deduced from the sand gradation. Furthermore, the sample sizes used in the Kolsky bar set-up are larger than the length scale of the microstructure of mortar, so that the samples are reasonably representative and provide a good basis of comparison with the micromechanics model. The micromechanics model is shown to provide reasonable agreement with experimentally obtained uniaxial compressive dynamic strength of air-entrained mortar.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/81095
    Collections
    • Journal of Engineering Mechanics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV