Show simple item record

dc.contributor.authorA. Hasnat
dc.contributor.authorM. M. Islam
dc.contributor.authorA. F. M. S. Amin
dc.date.accessioned2017-05-08T22:25:40Z
dc.date.available2017-05-08T22:25:40Z
dc.date.copyrightFebruary 2016
dc.date.issued2016
dc.identifier.other44519979.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/80455
dc.description.abstractIn simply-supported reinforced-concrete (RC) beams strengthened by carbon-fiber-reinforced polymer (CFRP) plates, plate debonding is initiated at the beam ends, where the principal compression, predominantly composed of a vertical component, detaches the plate externally bonded to the unconfined cover concrete. A CFRP wrap acting as a U-clamp can provide confinement to enhance the moment capacity by resisting premature cover debonding. The wrap design parameters in terms of clamping location, width, and stiffness were identified from a set of fundamental experiments. The ultimate moment capacities of 22 tested specimens with different end anchorage conditions were compared against control specimens. The debonding strain, and consequently the ultimate moment capacity, gradually increased with increasing U-clamp width and stiffness. The failure patterns confirmed the effect of U-clamps in inducing a partial confinement effect on the sides and bottom of a beam end. The resulting changes in the compressive principal stress distribution in the compression arch were considered in formulating relationships for debonding strain prediction. The proposed relationship successfully predicted values regarding strengthened stone and brick aggregate concrete beams. The relationships for both unclamped and U-clamped anchorages better reproduced the experimental moment capacity enhancements than did the known equations. To assess the derived relations’ wider applicability, the estimates obtained using the proposed relations were compared against published results for 42 test beams.
dc.publisherAmerican Society of Civil Engineers
dc.titleEnhancing the Debonding Strain Limit for CFRP-Strengthened RC Beams Using U-Clamps: Identification of Design Parameters
dc.typeJournal Paper
dc.journal.volume20
dc.journal.issue1
dc.journal.titleJournal of Composites for Construction
dc.identifier.doi10.1061/(ASCE)CC.1943-5614.0000599
dc.treeJournal of Composites for Construction:;2016:;Volume ( 020 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record