Show simple item record

dc.contributor.authorFrancisco Sena Cardoso
dc.contributor.authorKim J. R. Rasmussen
dc.date.accessioned2017-05-08T22:24:57Z
dc.date.available2017-05-08T22:24:57Z
dc.date.copyrightJuly 2014
dc.date.issued2014
dc.identifier.other44296716.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/80211
dc.description.abstractThe buckling behavior of T-section columns is discussed in detail, followed by a numerical study using geometric and material nonlinear analyses (GMNIA) to produce column strengths for a wide range of geometries of T-sections and column lengths. The T-sections are assumed to be hot-rolled and include residual stresses and geometric imperfections typical of hot-rolled sections. On the basis of the numerical strengths thus produced and the available test strengths for T-section columns, the design provisions of the Australian, European, and American specifications for hot-rolled steel structures are evaluated. It is shown that the Australian standard provides fairly consistent and accurate predictions of strength. However, the design provisions for T-sections of current European and American specifications are conservative and associated with large variability, particularly for T-sections with slender elements. The paper recommends modifications to the European and American specifications that improve the design strength predictions of these specifications for T-section columns.
dc.publisherAmerican Society of Civil Engineers
dc.titleBehavior and Design of Concentrically Loaded T-Section Steel Columns
dc.typeJournal Paper
dc.journal.volume140
dc.journal.issue7
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)ST.1943-541X.0000969
dc.treeJournal of Structural Engineering:;2014:;Volume ( 140 ):;issue: 007
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record