Show simple item record

dc.contributor.authorJiaji Du
dc.contributor.authorAlbert S. Kobayashi
dc.contributor.authorNeil M. Hawkins
dc.date.accessioned2017-05-08T22:22:36Z
dc.date.available2017-05-08T22:22:36Z
dc.date.copyrightOctober 1989
dc.date.issued1989
dc.identifier.other%28asce%290733-9399%281989%29115%3A10%282136%29.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/79052
dc.description.abstractA dynamic finite element model, which incorporated a fracture process zone and a maximum tensile stress failure criterion, was used to simulate the results of impact tests on concrete and mortar three‐point bend specimens. When the measured impact load was used as an input boundary condition to this dynamic finite element model, it predicted with reasonable accuracy the measured crack propagation history, the midspan deflection, and the notch tip strain. However, the numerical simulation showed that, in contrast to the modulus of rupture strengths obtained with impact loading, the dynamic tensile strengths appropriate for the fracture process zone model were relatively insensitive to the strain rate variations of
dc.publisherAmerican Society of Civil Engineers
dc.titleFEM Dynamic Fracture Analysis OF Concrete Beams
dc.typeJournal Paper
dc.journal.volume115
dc.journal.issue10
dc.journal.titleJournal of Engineering Mechanics
dc.identifier.doi10.1061/(ASCE)0733-9399(1989)115:10(2136)
dc.treeJournal of Engineering Mechanics:;1989:;Volume ( 115 ):;issue: 010
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record