Show simple item record

dc.contributor.authorAnnika Mårtensson
dc.date.accessioned2017-05-08T22:18:51Z
dc.date.available2017-05-08T22:18:51Z
dc.date.copyrightSeptember 1994
dc.date.issued1994
dc.identifier.other40467492.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/77255
dc.description.abstractThe effects on wood of simultaneous mechanical and moisture loading are studied. A constitutive model is given for the case of uniaxial stress in the longitudinal direction. The model has been quantified on the basis of test results found in literature. The validity of the model was checked independently against other tests and a number of practical load situations were studied. Finally the serviceablity requirements for design are discussed. The calculations show that the model is capable of describing the response of wood with reasonable accuracy. Some differences in behavior are found to depend on moisture cycling. The results of the simulations show that there is a significant influence of strain on the shrinkage and swelling response. An influence of beam dimensions has been found. The relative deflection for a small beam is larger than the deflection for a larger beam. Studies of the effect of varying load show that a temporarily applied load has little effect on the long‐term deflection of structural timber. A simulation of snow‐load variation shows that the long‐term deflections are small in comparison with the case when the characteristic load is assumed to be constant over time.
dc.publisherAmerican Society of Civil Engineers
dc.titleCreep Behavior of Structural Timber under Varying Humidity Conditions
dc.typeJournal Paper
dc.journal.volume120
dc.journal.issue9
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)0733-9445(1994)120:9(2565)
dc.treeJournal of Structural Engineering:;1994:;Volume ( 120 ):;issue: 009
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record