Show simple item record

dc.contributor.authorR. J. C. Carbas
dc.contributor.authorG. M. S. O. Viana
dc.contributor.authorL. F. M. da Silva
dc.contributor.authorG. W. Critchlow
dc.date.accessioned2017-05-08T22:17:42Z
dc.date.available2017-05-08T22:17:42Z
dc.date.copyrightApril 2015
dc.date.issued2015
dc.identifier.other40131632.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/76558
dc.description.abstractSeveral investigations have been made concerning the fracture behavior of scaled specimens of wood beams repaired with adhesively bonded carbon fiber reinforced polymer (CFRP). However, one of the problems associated to these joints is the fact that the stress distribution (shear and peel) is concentrated at the ends of the overlap, leading to premature failure of the joint. The stress concentration can be reduced with use of a functionally graded adhesive, in which the mechanical properties vary along the bond length. This can be achieved with a graded cure, in which the temperature varies along the bond length. In this study, the repair of wood structures with CFRP was made using a homogeneous cure and a graded cure. The graded cure was performed by induction heating. This technique has already been successfully tested in single lap joints to increase the strength of the joint. Two common types of defects on beams under bending loads were analyzed (compression and cross grain tension damage). Scaled specimens of damaged wood beams were repaired and tested under four point bending. The results show that the cross grain tension beams repaired with a graded bondline were able to withstand higher loads than the beams repaired with a homogeneous bondline. This failure load of the graded repaired beam increases with an increase of the overlap length.
dc.publisherAmerican Society of Civil Engineers
dc.titleFunctionally Graded Adhesive Patch Repairs of Wood Beams in Civil Applications
dc.typeJournal Paper
dc.journal.volume19
dc.journal.issue2
dc.journal.titleJournal of Composites for Construction
dc.identifier.doi10.1061/(ASCE)CC.1943-5614.0000500
dc.treeJournal of Composites for Construction:;2015:;Volume ( 019 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record