Show simple item record

dc.contributor.authorK. J. R. Rasmussen
dc.contributor.authorG. J. Hancock
dc.date.accessioned2017-05-08T22:15:06Z
dc.date.available2017-05-08T22:15:06Z
dc.date.copyrightAugust 1993
dc.date.issued1993
dc.identifier.other39997174.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/75207
dc.description.abstractThe paper presents tests on square and circular stainless steel tubular beams. An important part of the test program was to quantify the increase in bending strength resulting from cold‐work during the fabrication process. Tension and compression tests on coupons cut from finished tubes were also included in the test program. Stress‐strain curves for shear were obtained using the coupon test results and the concept of affinity factors. A design method is proposed for stainless steel tubular beams. The method incorporates the increase in strength produced by the cold‐rolling process and is validated by comparing it to the test strengths. Design rules are proposed for the bending and shear strengths and for combined bending and shear. The design procedure proposed is an extension of that described in the ASCE
dc.publisherAmerican Society of Civil Engineers
dc.titleDesign of Cold‐Formed Stainless Steel Tubular Members. II: Beams
dc.typeJournal Paper
dc.journal.volume119
dc.journal.issue8
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)0733-9445(1993)119:8(2368)
dc.treeJournal of Structural Engineering:;1993:;Volume ( 119 ):;issue: 008
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record