Show simple item record

dc.contributor.authorD. J. Oehlers
dc.contributor.authorM. S. Mohamed Ali
dc.contributor.authorWeimin Luo
dc.date.accessioned2017-05-08T22:13:20Z
dc.date.available2017-05-08T22:13:20Z
dc.date.copyrightMarch 1998
dc.date.issued1998
dc.identifier.other39889366.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/74106
dc.description.abstractIt is now fairly common practice to glue steel plates to the tension faces of existing reinforced concrete slabs, as it is an inexpensive and unobtrusive upgrading procedure for strengthening and stiffening. However, the application of this technique to continuous reinforced-concrete beams, as opposed to slabs, is severely restricted by premature debonding of the ends of the tension-face plates through the action of vertical shear forces, that is, shear peeling. An experimental study is presented in which steel plates are glued to the sides of reinforced-concrete beams specifically to inhibit shear peeling of the tension-face plates. The results are incorporated into a design procedure for plating the tension faces of continuous composite beams that can allow for any distribution of applied loads, any variation of the cross-section properties along the length of the beam, and the time effects of creep and shrinkage, as well as propped and unpropped construction. The procedure is then applied to the strengthening and stiffening of a continuous reinforced-concrete beam for strength and serviceability requirements.
dc.publisherAmerican Society of Civil Engineers
dc.titleUpgrading Continuous Reinforced Concrete Beams by Gluing Steel Plates to Their Tension Faces
dc.typeJournal Paper
dc.journal.volume124
dc.journal.issue3
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)0733-9445(1998)124:3(224)
dc.treeJournal of Structural Engineering:;1998:;Volume ( 124 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record