Show simple item record

dc.contributor.authorThomas J. Manuel
dc.contributor.authorGeoffrey L. Kulak
dc.date.accessioned2017-05-08T22:13:10Z
dc.date.available2017-05-08T22:13:10Z
dc.date.copyrightMarch 2000
dc.date.issued2000
dc.identifier.other39882645.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/74004
dc.description.abstractIn steel construction, sometimes bolts and welds must be combined in a single joint. Provisions for the design of these combination joints can be found in existing specifications, but the design rules generally have not been verified by physical tests. In addition, the rules appear to be illogical in some cases. An experimental study using full-scale tension lap splices that combined high-strength bolts and fillet welds was carried out in order to develop a better understanding of combination joints. The results showed that the orientation of the welds and the bearing condition of the bolts are two key factors that must be considered when determining the extent of load sharing in combination joints. Design recommendations based on the results of this study are presented.
dc.publisherAmerican Society of Civil Engineers
dc.titleStrength of Joints That Combine Bolts and Welds
dc.typeJournal Paper
dc.journal.volume126
dc.journal.issue3
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)0733-9445(2000)126:3(279)
dc.treeJournal of Structural Engineering:;2000:;Volume ( 126 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record