Show simple item record

dc.contributor.authorPedro Albrecht
dc.contributor.authorAdnan H. Sahli
dc.contributor.authorFateh Wattar
dc.date.accessioned2017-05-08T22:10:57Z
dc.date.available2017-05-08T22:10:57Z
dc.date.copyrightAugust 1987
dc.date.issued1987
dc.identifier.other37425095.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/72982
dc.description.abstractThis paper summarizes the results of 400 fatigue tests of high‐strength bolted joints that were reported in eight domestic and six foreign studies. The following variables were investigated: type of bolt and washer, bolt pattern, bolts‐to‐member strength ratio, initial bolt tension, yield strength, skew, joint length, and partial connection of member elements. The analysis of the data showed that within the limits on maximum stress imposed by the American Association of State Highway and Transportation Officials (AASHTO) specifications on edge distance, bolt spacing, etc., both friction‐type and bearing‐type joints can be designed to Category B on the basis of the gross area stress range. The fatigue of long bolted joints with more than four bolt rows in a line of stress must be lowered from Category B to C. The stress range in members that transfer load through some, but not all, cross‐sectional elements must be calculated using a reduced effective gross area.
dc.publisherAmerican Society of Civil Engineers
dc.titleFatigue Strength of Bolted Joints
dc.typeJournal Paper
dc.journal.volume113
dc.journal.issue8
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)0733-9445(1987)113:8(1834)
dc.treeJournal of Structural Engineering:;1987:;Volume ( 113 ):;issue: 008
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record