Show simple item record

dc.contributor.authorMahmoud Heristchian
dc.contributor.authorMehrtash Motamedi
dc.contributor.authorPouyan Pourakbar
dc.contributor.authorAli Shams
dc.date.accessioned2017-05-08T22:09:09Z
dc.date.available2017-05-08T22:09:09Z
dc.date.copyrightOctober 2015
dc.date.issued2015
dc.identifier.other34755337.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/72405
dc.description.abstractAccording to standards, the exposed steel column bases and other steel-concrete connections use anchor bolts to resist the tensile (or pullout) actions. The embedded steel sections can replace the anchor bolts in resisting pullout forces. This paper numerically studies the pullout behavior of embedded steel sections with end plates under various conditions. The numerical models are generated with a computer program. To support the numerical results, two I-sections with end plates are tested under pullout forces. Also, a number of test results on headed studs, available in the literature, are compared with the numerical results. One of the important conclusions of the study is that the shape of the embedded section does not seriously affect its pullout strength. The pullout strength is proportionally increased with the plan size of the end plate. However, the rate of increase in strength of headed I-sections is remarkably lower than that of the headed studs. Embedded sections with end plates can develop the pullout strength and stiffness capacities required by the design forces.
dc.publisherAmerican Society of Civil Engineers
dc.titleTensile Behavior of Embedded Steel Sections with End Plates
dc.typeJournal Paper
dc.journal.volume141
dc.journal.issue10
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)ST.1943-541X.0001222
dc.treeJournal of Structural Engineering:;2015:;Volume ( 141 ):;issue: 010
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record