Show simple item record

dc.contributor.authorElif
dc.contributor.authorCicek
dc.contributor.authorErol
dc.contributor.authorGuler
dc.contributor.authorTemel
dc.contributor.authorYetimoglu
dc.date.accessioned2017-05-08T22:06:52Z
dc.date.available2017-05-08T22:06:52Z
dc.date.copyrightOctober 2014
dc.date.issued2014
dc.identifier.other29007060.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/71625
dc.description.abstractThe paper presents vertical pressure values occurring under the center line of uniformly loaded laboratory model tests of a surface strip footing on a sand bed. The vertical pressure distribution in medium dense sand was measured using miniature pressure sensors. The experimental measures obtained from the model test program have been compared with values obtained from earlier theories. Tests were performed in plane strain conditions. Finally, the results obtained from experiments and theoretically obtained values were discussed. The results indicated that the distribution of pressure was not the same for every load level. It was found that the pressure distributions fit Westergaard distribution better at lower loads. They approach the pressure predicted by an earlier study as the applied loads reach bearing capacity values.
dc.publisherAmerican Society of Civil Engineers
dc.titleComparison of Measured and Theoretical Pressure Distribution below Strip Footings on Sand Soil
dc.typeJournal Paper
dc.journal.volume14
dc.journal.issue5
dc.journal.titleInternational Journal of Geomechanics
dc.identifier.doi10.1061/(ASCE)GM.1943-5622.0000347
dc.treeInternational Journal of Geomechanics:;2014:;Volume ( 014 ):;issue: 005
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record