Show simple item record

dc.contributor.authorAbdullah Al Mamun
dc.contributor.authorG. Doudak
dc.contributor.authorChun Ni
dc.contributor.authorMohammad Mohammad
dc.date.accessioned2017-05-08T22:06:03Z
dc.date.available2017-05-08T22:06:03Z
dc.date.copyrightJuly 2014
dc.date.issued2014
dc.identifier.other26290011.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/71344
dc.description.abstractExperimental results to determine the moment-resisting capacity of wood portal frame corner joints are presented in this paper. Two types of corner joints (standard and MIDPLY) were tested with different configurations. An L-shaped corner joint including a narrow braced wall segment and header was used as a test specimen. A total of 37 corner joints were tested. Test results showed that the installation of metal strap or the adding of exterior oriented strand board (OSB) sheathing, while using high-density wood product (LVL, LSL) as header increased the moment-resisting capacity of corner joints. Furthermore, the MIDPLY corner joint had higher moment capacity than the standard corner joint. The moment-carrying capacity of corner joints could be further increased by applying fiber-reinforced polymer (FRP) on top of exterior OSB sheathing. A detailed finite element (FE) model of a corner joint is presented. The FE model predictions correlated well with the experimental results.
dc.publisherAmerican Society of Civil Engineers
dc.titlePerformance Evaluation of Midply and Standard Corner Joints of Wood Portal Frames
dc.typeJournal Paper
dc.journal.volume140
dc.journal.issue7
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)ST.1943-541X.0000971
dc.treeJournal of Structural Engineering:;2014:;Volume ( 140 ):;issue: 007
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record