Show simple item record

dc.contributor.authorChristopher A. Trautner
dc.contributor.authorRasko P. Ojdrovic
dc.date.accessioned2017-05-08T22:00:59Z
dc.date.available2017-05-08T22:00:59Z
dc.date.copyrightApril 2014
dc.date.issued2014
dc.identifier.other%28asce%29st%2E1943-541x%2E0000912.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/68807
dc.description.abstractASCE 7-10 allows the design of the main wind force resisting system (MWFRS) of buildings with a mean roof height of less than 18.3 m (60 ft) by using either the directional procedure of Chapter 27 or the envelope procedure of Chapter 28 (sometimes referred to as the all heights and low-rise procedures, respectively). These two procedures were developed based on research that used very different methodologies to develop enveloped wind loads. As a result, the two methods may predict very different wind loads and subsequent structural behavior. This paper presents motivation for the research and a comparison of the structural demands calculated by using the two procedures; identifies some situations for which the low-rise procedures may give unconservative MWFRS member loads, proposes changes to the provisions, and identifies avenues for future research.
dc.publisherAmerican Society of Civil Engineers
dc.titleComparison of Directional and Envelope Wind Load Provisions of ASCE 7
dc.typeJournal Paper
dc.journal.volume140
dc.journal.issue4
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)ST.1943-541X.0000868
dc.treeJournal of Structural Engineering:;2014:;Volume ( 140 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record