• Login
    View Item 
    •   DSpace Home
    • ASCE
    • Journal of Structural Engineering
    • View Item
    •   DSpace Home
    • ASCE
    • Journal of Structural Engineering
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Normal Strain-Adjusted Shear Strength Expression for Fully Grouted Reinforced Masonry Structural Walls

    Thumbnail
    View/Open
    %28asce%29st%2E1943-541x%2E0000885.pdf (12.49Mb)
    Date
    2014
    Author
    Bennett R. Banting
    Wael W. El-Dakhakhni
    Metadata
    Show full item record
    Abstract
    Since the conclusion of the test programs carried out by the Joint U.S.–Japan Technical Coordinating Committee on Masonry Research (TCCMAR) during the 1970s and 1980s, there has been little progress made to enhance the shear strength expressions used for masonry design. The experimentally-derived expressions currently employed by North American design codes are based on the 45° cracked member assumption and truss analogy, where shear strength is expressed as an algebraic summation of resistance offered by masonry, axial load, and shear reinforcement. By contrast, the modified compression field theory (MCFT), which has gained a wide acceptance within the concrete design community, demonstrates that the 45° cracked member assumption can be overly conservative. Yet the MCFT or similar equilibrium-based approaches have often been thought of as incompatible with masonry due to the latter’s complex anisotropic behavior. However, seismic design detailing requirements within North America typically require the highly-susceptible plastic hinge region of structural (shear) walls to contain vertical and horizontal steel reinforcement in fully grouted concrete block units. Under these circumstances, the anisotropic effects are greatly reduced and the development of a simplified approach to estimate the equilibrium conditions at the shear-critical zone of masonry structural walls is possible. Tests on masonry panels conducted at McMaster University in Canada are used with existing literature to define a set of constitutive relationships for cracked masonry subject to stress states that are typical in reinforced masonry structural walls. Subsequently, a methodology is proposed to accurately estimate the angle of inclination of shear cracking and the shear resistance offered by the horizontal reinforcement and the masonry compression strut accounting for aggregate interlock effects. The proposed normal strain-adjusted shear strength expression (NSSSE) was found to predict the shear strength of 57 wall tests reported in literature with a mean ratio of experimental to theoretical strengths of
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/68780
    Collections
    • Journal of Structural Engineering

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV