Show simple item record

dc.contributor.authorGregory A. Kopp
dc.date.accessioned2017-05-08T22:00:47Z
dc.date.available2017-05-08T22:00:47Z
dc.date.copyrightFebruary 2014
dc.date.issued2014
dc.identifier.other%28asce%29st%2E1943-541x%2E0000867.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/68761
dc.description.abstractThe author examined wind loads on low-profile, roof-mounted solar arrays, placed on large, low-rise buildings with nearly flat roofs by using scale models in a boundary layer wind tunnel. The author also examined the effects of building size and array geometry on enveloping curves of area-averaged pressure coefficients, typical of use for design. It was found that wind loads on the array increase with building size; normalizing the effective wind area by the building wall size leads to enveloping curves that collapse onto a single curve for each array geometry. For tilt angles less than 10°, there is an approximate linear increase in the pressure coefficients as the tilt angle increases. For arrays with tilt angles of 10° or more, the wind loads do not depend significantly on the tilt angle and are relatively constant. Roof zones for wind loads on solar arrays are larger than roof zones for bare roofs and depend on the array tilt angle.
dc.publisherAmerican Society of Civil Engineers
dc.titleWind Loads on Low-Profile, Tilted, Solar Arrays Placed on Large, Flat, Low-Rise Building Roofs
dc.typeJournal Paper
dc.journal.volume140
dc.journal.issue2
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)ST.1943-541X.0000825
dc.treeJournal of Structural Engineering:;2014:;Volume ( 140 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record