• Login
    View Item 
    •   DSpace Home
    • ASCE
    • Journal of Structural Engineering
    • View Item
    •   DSpace Home
    • ASCE
    • Journal of Structural Engineering
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Provisions for Ductile Behavior of Timber-to-Steel Connections with Multiple Glued-In Rods

    Thumbnail
    View/Open
    %28asce%29st%2E1943-541x%2E0000778.pdf (9.817Mb)
    Date
    2013
    Author
    Gabriela
    Parida
    Helena
    Johnsson
    Massimo
    Fragiacomo
    Metadata
    Show full item record
    Abstract
    Connections with glued-in rods are very efficient, high-strength joints and can be successfully used, for example, for the anchorage of vertical timber elements to a foundation. Although extensive research was done on the pullout strength of single rods, few references can be found on the behavior of multiple glued-in rods. This paper presents the results of an experimental program carried out on timber-to-steel connections with multiple glued-in rods. Two series of 10 specimens with four large-diameter, glued-in rods made from mild steel (Series GB) and 10 specimens with 12 small-diameter, high-grade glued-in rods (Series GS) were tested to failure under monotonic tensile load. Both types of connections ultimately failed in a brittle manner; however, the GB series developed some plastic deformations prior to failure which was caused by the pullout of two rods and longitudinal splitting of the timber member. By comparing the experimental results with the analytical predictions, no significant group effect could be detected in the GB test series, and an overall acceptable approximation was found. In the GS test series, no final conclusion on the group effect could be drawn as several rods failed by nut-stripping. A parametric study using analytical formulas was carried out to investigate the effect of rod strength, rod diameter, glued length, and timber density on the connection performance. Based on the results of the parametric study and experimental tests, it can be concluded that the use of mild steel as well as more rods of larger diameter, properly spaced from each other, and from the edges are all effective measures to increase the connection ductility. Furthermore, by leaving a suitable length of rod unbonded between the steel plate and the glued length, it is possible to control ductility, providing all brittle failure modes have a higher strength capacity than the rod-yielding force. Special care should be taken during the manufacturing process to ensure good quality of gluing (required glued length and amount of adhesive) and rod alignment.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/68667
    Collections
    • Journal of Structural Engineering

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV