Show simple item record

dc.contributor.authorLip H.
dc.contributor.authorTeh
dc.contributor.authorBenoit P.
dc.contributor.authorGilbert
dc.date.accessioned2017-05-08T22:00:09Z
dc.date.available2017-05-08T22:00:09Z
dc.date.copyrightMarch 2013
dc.date.issued2013
dc.identifier.other%28asce%29st%2E1943-541x%2E0000716.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/68602
dc.description.abstractThis paper examines the accuracy of equations specified by the North American and Australasian steel structures codes for determining the net section tension capacity of a cold-formed steel angle brace bolted at one leg. The configurations tested in the laboratory include single equal angle, single unequal angle bolted at the wider leg, single unequal angle bolted at the narrow leg, double angles, and alternate angles. The steel materials used in the experiment are among those with the lowest ductility for which nominal tensile strength is permitted by cold-formed steel design codes to be fully utilized in structural design calculations. Based on a modification to the equation derived for channel braces bolted at the web, a design equation is proposed for determining the net section tension capacity of a cold-formed steel angle brace bolted at one leg. The proposed equation is demonstrated, through laboratory tests on 61 specimens composed of G450 sheet steel, to be more accurate than the code equations and those existing in the literature.
dc.publisherAmerican Society of Civil Engineers
dc.titleNet Section Tension Capacity of Cold-Reduced Sheet Steel Angle Braces Bolted at One Leg
dc.typeJournal Paper
dc.journal.volume139
dc.journal.issue3
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)ST.1943-541X.0000675
dc.treeJournal of Structural Engineering:;2013:;Volume ( 139 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record