Show simple item record

dc.contributor.authorGang
dc.contributor.authorLi
dc.contributor.authorLarry A.
dc.contributor.authorFahnestock
dc.contributor.authorHong-Nan
dc.contributor.authorLi
dc.date.accessioned2017-05-08T22:00:08Z
dc.date.available2017-05-08T22:00:08Z
dc.date.copyrightApril 2013
dc.date.issued2013
dc.identifier.other%28asce%29st%2E1943-541x%2E0000705.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/68590
dc.description.abstractSteel concentrically braced frame (CBF) systems are widely used in buildings to resist lateral loads, because they possess high lateral strength and stiffness. For seismic applications, braces dissipate energy through tension yielding and compression buckling, and the lateral response of the CBFs is dominated by the complex cyclic inelastic behavior of the braces. Significant effort has gone toward developing accurate and efficient brace models, and these models fall into three broad categories: finite element, phenomenological, and physical theory. Finite-element models are accurate but computationally expensive, and phenomenological models are computationally efficient but depend on experimental results for calibration. Physical theory models, which are based on fundamental structural behavior, provide a balance of efficiency and accuracy. The present research implements an existing brace physical theory model for use in the force analogy method, which is an accurate, efficient, and stable algorithm for conducting dynamic analysis when coupled with the state space formulation. The brace model, which uses two sliding plastic mechanisms to capture axial and lateral brace deflections and to relate these to the brace force, is validated against prior experimental results. The brace model is also implemented in a frame, where inelastic response occurs in both the frame and the braces, to demonstrate application of the model and the potential for simulating complex inelastic dynamic CBF behavior with the force analogy method.
dc.publisherAmerican Society of Civil Engineers
dc.titleSimulation of Steel Brace Hysteretic Response Using the Force Analogy Method
dc.typeJournal Paper
dc.journal.volume139
dc.journal.issue4
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)ST.1943-541X.0000664
dc.treeJournal of Structural Engineering:;2013:;Volume ( 139 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record