Show simple item record

dc.contributor.authorA. M.
dc.contributor.authorKanvinde
dc.contributor.authorLiu
dc.contributor.authorFu
dc.contributor.authorR. J.
dc.contributor.authorCooke
dc.date.accessioned2017-05-08T22:00:01Z
dc.date.available2017-05-08T22:00:01Z
dc.date.copyrightMarch 2013
dc.date.issued2013
dc.identifier.other%28asce%29st%2E1943-541x%2E0000682.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/68566
dc.description.abstractThe strength of fillet weld groups, loaded with an out-of-plane eccentricity, is controlled by complex interactions of weld yielding, as well as bearing between the connected parts. Current models that characterize connection strength, including those used in North American design specifications, are highly conservative, leading to oversized welds. These models are phenomenological, because the internal stress distribution within the welds is difficult to characterize experimentally. A new model is proposed for characterizing the strength of these connections. The model is based on insights developed from sophisticated finite-element (FE) simulations that feature accurate measurements of weld profiles, multiaxial plasticity, and simulation of contact and gapping phenomena that strongly influence connection response. The FE simulations reveal that current models do not reflect key aspects of force transfer within the connection, especially on the compression side. The proposed model incorporates these insights by using stress profiles and mechanisms consistent with those implied by the FE simulations. The model is evaluated against 79 experiments from three test programs. It is determined that the new model greatly reduces the conservatism of the existing models, resulting in an average test-to-predicted ratio of 1.01. This is in contrast to previous models, for which the average test-to-predicted ratios are in the range of 1.33–1.77. The efficacy of the proposed model is analyzed with respect to various parameters, and its limitations are outlined.
dc.publisherAmerican Society of Civil Engineers
dc.titleFillet Weld Groups Loaded with Out-of-Plane Eccentricity: Simulations and New Model for Strength Characterization
dc.typeJournal Paper
dc.journal.volume139
dc.journal.issue3
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)ST.1943-541X.0000641
dc.treeJournal of Structural Engineering:;2013:;Volume ( 139 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record