• Login
    View Item 
    •   DSpace Home
    • ASCE
    • Journal of Structural Engineering
    • View Item
    •   DSpace Home
    • ASCE
    • Journal of Structural Engineering
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Structural Behavior of CHS T-Joints Subjected to Brace Axial Compression in Fire Conditions

    Thumbnail
    View/Open
    %28asce%29st%2E1943-541x%2E0000644.pdf (1.293Mb)
    Date
    2013
    Author
    K. H.
    Tan
    T. C.
    Fung
    M. P.
    Nguyen
    Metadata
    Show full item record
    Abstract
    The structural behavior of circular hollow section (CHS) T-joints subjected to axial brace compression in fire conditions was investigated. Five full-scale tubular joints with different brace-to-chord diameter ratios were tested under elevated temperature. The tests were in isothermal heating conditions, where the specimens were heated to the desired temperatures and then subjected to static load to failure. The ultimate strength and failure modes of these joints were investigated. It was observed that both the reduction in material strength and changes in localized plastification area beneath the brace decreased the ultimate strength of the joints as temperature increased. Furthermore, local buckling and ovalisation of the chords were found to be more concentrated around the joint region at elevated temperature. To the authors’ best knowledge, these tests were among the first reported experimental investigations in the ultimate strength and failure mechanisms of tubular joints at elevated temperature. To investigate the joint behavior at high temperature in greater detail, FEM was used. The finite-element models were first validated by the test results. The development of failure mechanisms of CHS T-joints at elevated temperature was then traced with the numerical models. The models were also used to quantify the effect of elevated temperatures on three parameters that directly affect the ultimate strength of the T-joints. The three parameters are boundary condition, precompression in the chord, and chord thickness.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/68525
    Collections
    • Journal of Structural Engineering

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV