• Login
    View Item 
    •   DSpace Home
    • ASCE
    • Journal of Structural Engineering
    • View Item
    •   DSpace Home
    • ASCE
    • Journal of Structural Engineering
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Flexural Demand on Pin-Connected Buckling-Restrained Braces and Design Recommendations

    Thumbnail
    View/Open
    %28asce%29st%2E1943-541x%2E0000589.pdf (268.4Kb)
    Date
    2012
    Author
    Junxian
    Zhao
    Bin
    Wu
    Jinping
    Ou
    Metadata
    Show full item record
    Abstract
    In a previous study by the authors, the cyclic behavior of a novel type of pin-connected angle steel buckling-restrained brace (ABRB) was examined, and the failure mechanism in the core projection of the ABRB induced by an excessive bending effect caused by end rotation was discussed. In this paper, the occurrence mechanism of end rotation modes and the bending effect in the core projection of an ABRB are first investigated based on the previous test results, which shows that end rotation demands would be significantly increased with the presence of a gap and an additional bending effect could be observed if the end rotation demands were large enough to cause two-point contact at the core ends. Then, a new method to predict the flexural demand on pin-connected BRBs is proposed by considering the effect of the end rotation modes, clearance, initial eccentricity, and initial deflection of casing. The design criteria to prevent yielding of the core projection are presented and further verified by the previous test results. Furthermore, the effects of key influential parameters on the flexural demand on core projection are discussed based on the analytical results. It is found that such a bending effect can be significantly reduced by decreasing the gap or increasing the constrained length of the core stiffening segment. The C-mode end rotation with single curvature bending configuration is found to be generally the most unfavorable case for core projection design. Finally, several design recommendations are provided for pin-connected BRBs.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/68463
    Collections
    • Journal of Structural Engineering

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV