| dc.contributor.author | L. Rhode-Barbarigos | |
| dc.contributor.author | C. Schulin | |
| dc.contributor.author | N. Bel Hadj Ali | |
| dc.contributor.author | R. Motro | |
| dc.contributor.author | I. F. C. Smith | |
| dc.date.accessioned | 2017-05-08T21:59:42Z | |
| dc.date.available | 2017-05-08T21:59:42Z | |
| dc.date.copyright | April 2012 | |
| dc.date.issued | 2012 | |
| dc.identifier.other | %28asce%29st%2E1943-541x%2E0000532.pdf | |
| dc.identifier.uri | http://yetl.yabesh.ir/yetl/handle/yetl/68401 | |
| dc.description.abstract | Tensegrity structures are spatial systems composed of tension and compression components in a self-equilibrated prestress stable state. Although the concept is over 60 years old, few tensegrity-based structures have been used for engineering purposes. Tensegrity-ring modules are deployable modules composed of a single strut circuit that, when combined, create a hollow rope. The “hollow-rope” concept was shown to be a viable system for a tensegrity footbridge. This paper focuses on the deployment of pentagonal ring modules for a deployable footbridge application. The deployment sequence of a module is controlled by adjusting cable lengths (cable actuation). The geometric study of the deployment for a single module identified the path space allowing deployment without strut contact. Additionally, a deployment path that reduces the number of actuated cables was found. The number of actuated cables is further reduced by employing continuous cables. A first-generation prototype was used to verify both findings experimentally. The structural response during both unfolding and folding is studied numerically using the dynamic relaxation method. The deployment-analysis algorithm applies cable-length changes first to create finite mechanisms allowing deployment and then to find new equilibrium configurations. Therefore, the actuation-step size is identified as the most critical parameter for a successful deployment analysis. Finally, it is shown that the deployability of the footbridge does not affect its element sizing because stresses during deployment are lower than in-service values. | |
| dc.publisher | American Society of Civil Engineers | |
| dc.title | Mechanism-Based Approach for the Deployment of a Tensegrity-Ring Module | |
| dc.type | Journal Paper | |
| dc.journal.volume | 138 | |
| dc.journal.issue | 4 | |
| dc.journal.title | Journal of Structural Engineering | |
| dc.identifier.doi | 10.1061/(ASCE)ST.1943-541X.0000491 | |
| dc.tree | Journal of Structural Engineering:;2012:;Volume ( 138 ):;issue: 004 | |
| dc.contenttype | Fulltext | |