• Login
    View Item 
    •   DSpace Home
    • ASCE
    • Journal of Structural Engineering
    • View Item
    •   DSpace Home
    • ASCE
    • Journal of Structural Engineering
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Comparisons of the Computed and Measured Behavior of Curved Steel I-Girders during Lifting

    Thumbnail
    View/Open
    %28asce%29st%2E1943-541x%2E0000458.pdf (643.2Kb)
    Date
    2012
    Author
    Jason C. Stith
    Todd A. Helwig
    Eric B. Williamson
    Karl H. Frank
    Michael D. Engelhardt
    Andrew C. Schuh
    Jamie F. Farris
    Metadata
    Show full item record
    Abstract
    The stability of I-girders during erection can be difficult to assess because of the limited presence of bracing and uncertainty in the support conditions of the girders. The behavior of curved girders during the early stages of construction is complicated because the curved geometry can lead to significant torsion. This paper highlights results from a research study that included both field monitoring and parametric finite-element investigations. Curved I-shaped girders were instrumented and monitored during lifting to provide data to validate finite-element models. Both rotational displacements and stress were measured during the lifting process. In this paper, the writers compare data collected from field tests with results computed from detailed finite-element simulations. A prismatic and a nonprismatic girder (with two different cross sections) were considered in the investigation. The I-girders experienced both rigid body rotation and cross-sectional twist. Additionally, the torsional warping stresses were observed to be of the same order of magnitude as the strong-axis bending stresses. However, it should be noted that the total stresses were well below yielding. The fact that the stresses are low during lifting should not be confused with a noncritical stage in the safety of the girders. Although the applied stresses are low, the stresses necessary to buckle the girder or to cause large deformations are also relatively low because usually no bracing exists and limited restraint is provided to the girders during lifting. The finite-element models were able to capture the measured behavior accurately, providing insight into appropriate assumptions and critical features for modeling curved I-girders during lifting.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/68324
    Collections
    • Journal of Structural Engineering

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV